A Mistuned Forced Response Analysis of an Embedded Compressor Blisk Using a Reduced-Order Model

Published

Journal Article

© 2019 by ASME. Accuracy when assessing mistuned forced response analyses is still a major concern. Since a fully coupled analysis is still very computational expensive, several simplifications and reduced-order models (ROMs) are carried out. The use of a reduction method, the assumptions and simplifications, generate different uncertainties that challenge the accuracy of the results. Experimental data are needed for validation and also to understand the propagation of these uncertainties. This paper shows a detailed mistuned forced response analysis of a compressor blisk. The blisk belongs to the Purdue Three-Stage (P3S) Compressor Research Facility. Two different stator-rotor-stator configurations of 38 and 44 upstream stator vanes are taken into consideration. Several loading conditions are analyzed at three different speed lines. A ROM known as subset nominal mode (SNM), has been used for all the analyses. This reduction takes as a basis a set of modes within a selected frequency spectrum. It can consider a complete family of modes to study the disk-blade modal interaction. A detailed comparison between the predicted and measured results has been performed, showing a good agreement for the high loading (HL) conditions.

Full Text

Duke Authors

Cited Authors

  • Gutierrez Salas, M; Petrie-Repar, P; Kielb, RE; Key, NL

Published Date

  • March 1, 2019

Published In

Volume / Issue

  • 141 / 3

Electronic International Standard Serial Number (EISSN)

  • 1528-8919

International Standard Serial Number (ISSN)

  • 0742-4795

Digital Object Identifier (DOI)

  • 10.1115/1.4041280

Citation Source

  • Scopus