Limit cycle oscillations of delta wing models in low subsonic flow


Journal Article

A nonlinear, aeroelastic analysis of a low aspect, delta wing modeled as a plate of constant thickness demonstrates that limit cycle oscillations (LCO) of the order of the plate thickness are possible. The structural nonlinearity arises from double bending in both the chordwise and spanwise directions. The present results using a vortex lattice aerodynamic model for a low Mach number flow complement earlier studies for rectangular wing platforms that showed similar qualitative results. The theoretical results for the flutter boundary (beyond which LCO occurs) have been validated by comparison to the experimental data reported by other investigators for low aspect ratio delta wings. Also the limit cycle oscillations found experimentally by previous investigators (but not previously quantified prior to the present work) are consistent with the theoretical results reported here. Reduced order aerodynamic and structural models are used to substantially decrease computational cost with no loss in accuracy. Without the use of reduced order models, calculations of the LCO would be impractical. A wind tunnel model is tested to provide a quantitative experimental correlation with the theoretical results for the LCO response itself.

Duke Authors

Cited Authors

  • Tang, D; Henry, JK; Dowell, EH

Published Date

  • January 1, 1999

Published In

Volume / Issue

  • 3 /

Start / End Page

  • 2162 - 2172

International Standard Serial Number (ISSN)

  • 0273-4508

Citation Source

  • Scopus