Design and fabrication of fiber-optic nanoprobes for optical sensing

Journal Article (Journal Article)

This paper describes the design and fabrication of fiber-optic nanoprobes developed for optical detection in single living cells. It is critical to fabricate probes with well-controlled nanoapertures for optimized spatial resolution and optical transmission. The detection sensitivity of fiber-optic nanoprobe depends mainly on the extremely small excitation volume that is determined by the aperture sizes and penetration depths. We investigate the angle dependence of the aperture in shadow evaporation of the metal coating onto the tip wall. It was found that nanoaperture diameters of approximately 50 nm can be achieved using a 25° tilt angle. On the other hand, the aperture size is sensitive to the subtle change of the metal evaporation angle and could be blocked by irregular metal grains. Through focused ion beam (FIB) milling, optical nanoprobes with well-defined aperture size as small as 200 nm can be obtained. Finally, we illustrate the use of the nanoprobes by detecting a fluorescent species, benzo[a] pyrene tetrol (BPT), in single living cells. A quantitative estimation of the numbers of BPT molecules detected using fiber-optic nanoprobes for BPT solutions shows that the limit of detection was approximately 100 molecules. © 2010 Zhang et al.

Duke Authors

Cited Authors

  • Zhang, Y; Dhawan, A; Vo-Dinh, T

Published Date

  • January 1, 2012

Published In

Volume / Issue

  • 7 /

Start / End Page

  • 6 - 18

Electronic International Standard Serial Number (EISSN)

  • 1556-276X

International Standard Serial Number (ISSN)

  • 1931-7573

Citation Source

  • Scopus