Skip to main content

Quantitative breast tomosynthesis: from detectability to estimability.

Publication ,  Journal Article
Richard, S; Samei, E
Published in: Med Phys
December 2010

PURPOSE: This work aimed to extend Fourier-based imaging metrics for modeling and predicting quantitative imaging performance. The new methodology was applied to the platform of breast tomosynthesis for investigating the influence of acquisition parameters (e.g., acquisition angle and dose) on quantitative imaging performance. METHODS: Two quantitative imaging tasks were considered: Area estimation and volume estimation of a 4 mm diameter spherical target. The maximum likelihood estimator yielded training data to generate a size estimation task function, which was combined with the MTF and NPS to predict estimation performance by computing an "estimability index" analogous to the detectability index. Estimation performance for the two tasks was computed as a function of acquisition angle and dose. The results were used for system optimization in terms of quantitation performance and further compared to the detectability index for the detection of the same spherical target. RESULTS: The estimability index computed with the size estimation tasks correlated well with precision measurements for area and volume estimation over a broad range of imaging conditions and provided a meaningful figure of merit for quantitative imaging performance and optimization. The results highlighted that optimal breast tomosynthesis acquisition parameters depend significantly on imaging task and dose. At nominal dose (1.5 mGy), mass detection was optimal at an acquisition angle of 85 degrees, while area and volume estimation for the same mass were optimal at approximately 125 degrees and 164 degrees acquisition angles, respectively. CONCLUSIONS: These findings provide an initial validation that the Fourier-based metrics extended to estimation tasks can represent a meaningful metric and predictor of quantitative imaging performance. The optimization framework also revealed trade-off between anatomical noise and system noise in volumetric imaging systems potentially identifying different optimal acquisition parameters than currently used in breast tomosynthesis and CT.

Duke Scholars

Published In

Med Phys

DOI

ISSN

0094-2405

Publication Date

December 2010

Volume

37

Issue

12

Start / End Page

6157 / 6165

Location

United States

Related Subject Headings

  • Reproducibility of Results
  • Radiographic Image Enhancement
  • Radiation Dosage
  • Phantoms, Imaging
  • Nuclear Medicine & Medical Imaging
  • Mammography
  • Fourier Analysis
  • Breast Neoplasms
  • Breast
  • 5105 Medical and biological physics
 

Citation

APA
Chicago
ICMJE
MLA
NLM
Richard, S., & Samei, E. (2010). Quantitative breast tomosynthesis: from detectability to estimability. Med Phys, 37(12), 6157–6165. https://doi.org/10.1118/1.3501883
Richard, Samuel, and Ehsan Samei. “Quantitative breast tomosynthesis: from detectability to estimability.Med Phys 37, no. 12 (December 2010): 6157–65. https://doi.org/10.1118/1.3501883.
Richard S, Samei E. Quantitative breast tomosynthesis: from detectability to estimability. Med Phys. 2010 Dec;37(12):6157–65.
Richard, Samuel, and Ehsan Samei. “Quantitative breast tomosynthesis: from detectability to estimability.Med Phys, vol. 37, no. 12, Dec. 2010, pp. 6157–65. Pubmed, doi:10.1118/1.3501883.
Richard S, Samei E. Quantitative breast tomosynthesis: from detectability to estimability. Med Phys. 2010 Dec;37(12):6157–6165.

Published In

Med Phys

DOI

ISSN

0094-2405

Publication Date

December 2010

Volume

37

Issue

12

Start / End Page

6157 / 6165

Location

United States

Related Subject Headings

  • Reproducibility of Results
  • Radiographic Image Enhancement
  • Radiation Dosage
  • Phantoms, Imaging
  • Nuclear Medicine & Medical Imaging
  • Mammography
  • Fourier Analysis
  • Breast Neoplasms
  • Breast
  • 5105 Medical and biological physics