Microwave hyperthermia induced by a phased interstitial antenna array
An interstitial microwave antenna array for hyperthermia cancer treatment is investigated. The purpose is to generate both uniform and controlled nonuniform temperature distributions in biological tissue by modulating the phases of the signals applied to each antenna. The array has four antennas positioned on the corners of a 2 cm square. The distributions of absorbed power within the arrays are computed and then converted into temperature distributions through a heat conduction simulation. The temperature patterns over phantom muscle are presented in both the lateral plane (perpendicular to the antennas) and the axial plane (parallel to the antennas). It is found that by proper phase modulation of radio frequency signals applied to each antenna, a uniform heating can be produced in the entire array volume.
Duke Scholars
Published In
DOI
Publication Date
Volume
Issue
Start / End Page
Related Subject Headings
- Networking & Telecommunications
- 5103 Classical physics
- 1005 Communications Technologies
- 0906 Electrical and Electronic Engineering
Citation
Published In
DOI
Publication Date
Volume
Issue
Start / End Page
Related Subject Headings
- Networking & Telecommunications
- 5103 Classical physics
- 1005 Communications Technologies
- 0906 Electrical and Electronic Engineering